Manual cat 3412 dita engine spec. Class H Temperature rise..125 deg C above 40 deg C ambient (Class H) Governing StandardsIS4722 (2001), BS 5000( Part 99), IEC:60034-1 Enclosure protection. Stator winding connectionStar connected Insulation. • INSTALLATION MANUAL MODULATING ECM RESIDENTIAL GAS FURNACES MODELS: TP9C, YP9C, CP9C, and LP9C Series When paired with a (Up to 98% AFUE Multi-position) York heat pump LIST OF SECTIONS SAFETY... 2 START-UP AND ADJUSTMENTS. • 1083292-UIM-A-0114 The York YP9C is part of a “Hybrid Comfort System” when paired with a which has an external static pressure within the allowable range, as specified on the furnace rating plate. York Heat pump. When a furnace is installed so that supply ducts carry air circulated. • 1083292-UIM-A-0114 CODES AND STANDARDS • Furnaces for upflow installation on combustible flooring shall not be installed directly on carpeting, tile or other combustible mate- Follow all national, local codes and standards in addition to this installa- rial other than wood flooring. INSTALLATION MANUAL LIST OF SECTIONS. This product must be installed in st rict compliance with the installation instructions and any applicable local, state, and national codes including, but not limited to buildi ng, electrical, and mechanical codes. Improper installation may result in water leakage, electrical shock and fire, or cause the. S Strictly follow the installation instructions set forth in this manual. York Hvac Installation Manuals installation manual - york - 548086-xim-a-0310 johnson controls unitary products 3 ground installation the unit should be. York Yk Chiller Installation Manual model yk centrifugal liquid chiller style g - form 160.75-eg1 (517) model yk centrifugal liquid chiller style g 250 through 3000. • 1083292-UIM-A-0114 Where it will not interfere with proper air circulation in the confined FOR FURNACES INSTALLED IN THE COMMON- space. WEALTH OF MASSACHUSETTS ONLY Where the outdoor vent terminal will not be blocked or restricted. For all side wall horizontally vented gas fueled equipment installed in Refer to “VENT CLEARANCES”. • 1083292-UIM-A-0114 SECTION II: DUCTWORK On all installations without a coil, a removable access panel is recom- mended in the outlet duct such that smoke or reflected light would be DUCTWORK GENERAL INFORMATION observable inside the casing to indicate the presence of leaks in the The duct system’s design and installation must: heat exchanger. • 1083292-UIM-A-0114 LINE CONTACT ONLY PERMISSIBLE BETWEEN LINES FORMED BY THE SUPPLY AIR INTERSECTION OF FURNACE TOP AND TWO SIDES AND BUILDING JOISTS, STUDS OR FRAMING VENT (Maintain FURNACE required clearances to combustibles) FILTER RACK MUST BE A MINIMUM GAS PIPING WARM AIR PLENUM DISTANCE WITH 1”. • 1083292-UIM-A-0114 COIL INSTALLATION On all installations without a coil, a removable access panel is rec- ommended in the outlet duct such that smoke or reflected light Support would be observable inside the casing to indicate the presence of leaks in the heat exchanger. This access cover shall be attached in such a manner as to prevent leaks. • 1083292-UIM-A-0114 FURNACE ASSEMBLY - MC SERIES COILS ONLY MC coils are supplied ready to be installed in a horizontal position. A horizontal pan is factory installed. MC coils should be installed in all hor- (Min) izontal applications with the horizontal drain pan side down. Mounting Plate Flexible Duct Collar. York D2cg300 Installation Instruction Manual• 1083292-UIM-A-0114 LEFT SIDE RIGHT SIDE FRONT Combustion Air Inlet Combustion Air Inlet Condensate Drain Gas Pipe Gas Pipe Condensate Drain (Downflow) Entry Entry (Downflow) 2” Vent Electrical Electrical Connection Entry 2” Vent Entry Outlet Connection Condensate Outlet Drain Condensate 23” Drain Thermostat Wiring. • 1083292-UIM-A-0114 Horizontal Filters Main Inlet On/Off Regulator Pressure Switch Adjustment All filters and mounting provision must be field supplied. All installa- Outlet tions must have a filter installed. Pressure Any branch duct (rectangular or round duct) attached to the plenum must attach to the vertical plenum before the filter. • 1083292-UIM-A-0114 GAS CONVERSION FOR PROPANE (LP) Read across that row to the column for the elevation at your loca- tion. The number listed there is the orifice size that is proper for This furnace is constructed at the factory for natural gas-fired operation, your unit. • 1083292-UIM-A-0114 Table 6: Ratings & Physical / Electrical Data Input Output Nominal Air Temp.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |